HOME

CellFlo

Technical

 

 

 

 

 

CellFlo Portable Foam Porosity Meter

Technical Information

The principle of the CellFlo Foam Porosity tester is to blow air through the foam at a controlled pressure and measure the air flow volume through the foam. Air flow is displayed on a digital meter on a range of 0 - 100 (zero flow to unrestricted flow).

The porosity meter contains:

       Battery power supply ( 2 x AA cells )

       Electronic circuits - latest SMD technology

       Precision air blower

       LCD digital display

The electronic circuits have been designed to give maximum stability. The power supply is stabilised to eliminate effects of reduced battery power. When the batteries run down to an unacceptable voltage, a warning light is displayed.

Simple djustments are provided for zero and maximum readings. This enables the user to calibrate the instrument at locations of different altitude. Air density and viscosity decrease at higher altitude, so the effect of the foam on air flow changes. These calibration adjustments allow the CellFlo Porosity Meter to be used at any location.

Tough moulded ABS case - ergonomically designed with soft edge grip for hand-held comfort.

 

Pocket sized - light weight!

 

Technical Specification

Dimensions:

    Length       12 cm (4.7 inch)

    Width           8 cm (3.1 inch)

    Thickness    2.5 cm (1.0 inch)

Weight - with 2 x AA batteries fitted:   only 200 grams (7.0 ounce)

Power supply:    3 volts 0.8W (2 x 1.5 volt AA cells eg. Duracell MN 1500, Energizer E91. Rechargeable AA Alkaline or Ni-Mh cells may also be used). Low battery indication by red LED light.

Comprehensive illustrated Instruction Manual

Optional leather carrying case